PCB Trace Width Calculator

A copper track that is too narrow gets hot, and a hot track is a failing track. This calculator uses the IPC-2221 formula to give you the minimum width for a given current.

Work it out

How this works

The formula

Area = (I / (k x dT raised to 0.44)) raised to the power 1 / 0.725, where k is 0.048 for an outer copper layer. The width is that area divided by the copper thickness, and 1 oz of copper is 1.378 mils, or 0.035 mm.

The result assumes an outer layer with air above and below it and a stated temperature rise, usually 10 degrees C.

Worked example

One amp on 1 oz copper with a 10 degree C rise needs an area of about 16.3 square mils. Dividing by the copper thickness gives 11.8 mils, which is 0.30 mm.

Round that up to 0.4 mm on the drawing so the board house has a sensible target, and keep the current well under the limit if the track runs in free air.

Common mistake

Treating an outer track the same as an inner one. A track on the outer layer with a ground plane beside it, or a plated through hole, loses heat much better than an isolated outer trace, so it can be narrower. An inner layer sandwiched between two planes is the case that needs the widest track of all.

Parts for this

These are the parts you solder onto a board. Their pads and pins are what the copper tracks have to carry. Prices and availability are read live when this page is built.

Next step

ALAI is a member AI assistant and can be wrong. Digital VIP or an active TechCrate subscription is required for member answers. Low voltage hobby electronics only, no mains work.

Other free calculators

All calculators on one page

Free Shipping

On orders over $50

Fast Shipping

Ships within 24 hours

Secure Checkout

256-bit SSL encrypted

Family Owned

Since 2013 in Pine Hill, NJ

Follow us for tutorials, product demos, and maker inspiration!
Added to Cart!