Im having so much fun with this kit! I ran into my first noob problem with the CMOS decade counter CD4026BE. I wired up this circuit from make electronics and I think I had a issue or maybe burned the IC crossing the power as the LED display lit up all segments at one point and looked like this in the end.. I may have moved wires checking my work though. this is so cool though!
Workbench Circuit Photos
TechCrate editorial answer
Bench Answer
All segments lighting up at once on a CD4026BE-driven display is usually not permanent chip damage — it's most often caused by the **RESET pin (pin 7) floating or being pulled HIGH** unintentionally, or the **DISPLAY ENABLE IN pin (pin 3) left floating** instead of tied to a defined level, both of which can make the segment outputs behave erratically rather than showing a clean digit. **Quick CD4026BE pinout reference (16-pin DIP):**
- Pin 1: **Clock** (counts up on each rising edge)
- Pin 2: **Clock Inhibit** (hold LOW to allow counting)
- Pin 3: **Display Enable In** (tie HIGH/to Vdd if you're not cascading multiple chips)
- Pins 4, 5, 6: segment outputs c, d, e
- Pin 7: **Reset** (active HIGH — pulls the count back to zero; must be tied LOW, not left floating, when not in use)
- Pin 8: **Vss** (ground)
- Pin 9: ungated **Carry Out**
- Pins 10, 11: segment outputs b, a
- Pins 12, 13: segment outputs f, g
- Pin 14: **Display Enable Out** (for cascading)
- Pin 15: gated **Carry Out** (one pulse per 10 counts, used to chain a second CD4026 for multi-digit counters)
- Pin 16: **Vdd** (positive supply)
**What to check on your breadboard:**
- Pin 1: **Clock** (counts up on each rising edge)
- Pin 2: **Clock Inhibit** (hold LOW to allow counting)
- Pin 3: **Display Enable In** (tie HIGH/to Vdd if you're not cascading multiple chips)
- Pins 4, 5, 6: segment outputs c, d, e
- Pin 7: **Reset** (active HIGH — pulls the count back to zero; must be tied LOW, not left floating, when not in use)
- Pin 8: **Vss** (ground)
- Pin 9: ungated **Carry Out**
- Pins 10, 11: segment outputs b, a
- Pins 12, 13: segment outputs f, g
- Pin 14: **Display Enable Out** (for cascading)
- Pin 15: gated **Carry Out** (one pulse per 10 counts, used to chain a second CD4026 for multi-digit counters)
- Pin 16: **Vdd** (positive supply)
**What to check on your breadboard:**
Unlock the full bench walkthrough
Members get the complete diagnostic workflow, every measurement to take and the verification checklist.
Unlock Digital VIP · $4.99/mo →
