TechCrate 005 — Lucky Number Spinner: help

Hold the button to spin a glowing number, then let go to stop on a digit. Build with a 555 timer and 4026 counter, and explore the optional resistor challenge.

View this volume in the store

Parts for this build

Experiment contents from the live store listing. Keep your reusable Starter Kit: breadboard, 9 V battery, snap connector and jumper wires.

Five likely faults and first checks

Disconnect the battery before moving a lead or checking resistance. If anything gets hot or smells unusual, remove the battery immediately. Use only the kit's low voltage battery supply.

Display is dark

The initial pattern may be blank. Briefly hold the button; if still dark disconnect and check the common cathode, both chips and display orientation.

Number never changes

Power off. Trace 555 pin 3 to 4026 pin 1, check reset pin 15 is low and display enable pin 3 high, then inspect the button at inhibit pin 2.

Digit is incomplete

After briefly holding the button, disconnect and trace all seven segment paths and their separate 10k resistors. Do not bridge or bypass them.

It keeps counting after release

Disconnect and check the 10k pull-up from inhibit pin 2 to positive and that the two-pin button releases the ground connection.

Display looks dim

The supplied 10k segment resistors intentionally limit current. View away from bright light. Do not replace or bypass them for brightness.

These checks supplement your volume guide. They do not replace its schematic or certify your wiring.

Ask ALAI about Volume 005

Members can ask with this volume's circuit facts preloaded. Sign in to check your access or meet ALAI.

Free Shipping

On orders over $50

Fast Shipping

Ships within 24 hours

Secure Checkout

256-bit SSL encrypted

Family Owned

Since 2013 in Pine Hill, NJ

Follow us for tutorials, product demos, and maker inspiration!
Added to Cart!