TechCrate 004 — Spooky Eyes Jack O’Lantern: help

Build two blinking LED eyes that switch on in darkness. A 555 timer controls the flashes while a phototransistor responds to light.

View this volume in the store

Parts for this build

Experiment contents from the live store listing. Keep your reusable Starter Kit: breadboard, 9 V battery, snap connector and jumper wires.

Five likely faults and first checks

Disconnect the battery before moving a lead or checking resistance. If anything gets hot or smells unusual, remove the battery immediately. Use only the kit's low voltage battery supply.

Eyes never light

Test in darkness by covering the sensor. With power removed check 555 supply, sensor connections and reset pull-up.

Eyes stay on in light

Check phototransistor collector at RESET pin 4, emitter at ground, and the separate 100k pull-up. Confirm the actual package pinout.

Only one eye blinks

Each LED needs its own 470 ohm series resistor from pin 3 and cathode return to ground. Check the failed branch with power off.

Eyes are steady in darkness

Check pins 2/6, 10µF polarity and the 10k/100k pin-7 timing network. Do not confuse the two 100k resistors.

A part heats or smells unusual

Remove the battery. Check shorts, supply polarity and chip orientation. Do not test inside a wet pumpkin or near a flame.

These checks supplement your volume guide. They do not replace its schematic or certify your wiring.

Ask ALAI about Volume 004

Members can ask with this volume's circuit facts preloaded. Sign in to check your access or meet ALAI.

Free Shipping

On orders over $50

Fast Shipping

Ships within 24 hours

Secure Checkout

256-bit SSL encrypted

Family Owned

Since 2013 in Pine Hill, NJ

Follow us for tutorials, product demos, and maker inspiration!
Added to Cart!