TechCrate 002 — Police Siren: help

Build a two-tone police siren with two 555 timer chips and an 8-ohm speaker. Explore how one timer changes the tone produced by the other.

View this volume in the store

Parts for this build

Experiment contents from the live store listing. Keep your reusable Starter Kit: breadboard, 9 V battery, snap connector and jumper wires.

Five likely faults and first checks

Disconnect the battery before moving a lead or checking resistance. If anything gets hot or smells unusual, remove the battery immediately. Use only the kit's low voltage battery supply.

No sound

Power off. Check both chips have pin 1 at ground and pins 4/8 at positive, then trace the speaker return and output coupling capacitor.

One steady tone

Check the slow timer output path through 1k to the second timer control pin 5 and the 1000µF smoothing capacitor.

Only a click

Check the 0.1µF timing capacitor and both 10k tone-timer resistors. A speaker click alone does not prove oscillation.

Sweep is too slow or missing

Check the slow timer 33k/100µF timing pair; distinguish the 100µF timing part from the 1000µF smoothing part.

A part gets warm

Disconnect immediately. Check electrolytic polarity and shorts. The speaker must retain the series 10µF coupling capacitor; never connect it straight across the battery.

These checks supplement your volume guide. They do not replace its schematic or certify your wiring.

Ask ALAI about Volume 002

Members can ask with this volume's circuit facts preloaded. Sign in to check your access or meet ALAI.

Free Shipping

On orders over $50

Fast Shipping

Ships within 24 hours

Secure Checkout

256-bit SSL encrypted

Family Owned

Since 2013 in Pine Hill, NJ

Follow us for tutorials, product demos, and maker inspiration!
Added to Cart!