TechCrate 001 — Railroad Crossing Signal: help

Build a railroad crossing signal with two red LEDs that flash in turn. Use a 555 timer, resistors and a capacitor to explore how electronic timing controls the lights.

View this volume in the store

Parts for this build

Experiment contents from the live store listing. Keep your reusable Starter Kit: breadboard, 9 V battery, snap connector and jumper wires.

Five likely faults and first checks

Disconnect the battery before moving a lead or checking resistance. If anything gets hot or smells unusual, remove the battery immediately. Use only the kit's low voltage battery supply.

Both eyes stay dark

Disconnect the battery, then trace the snap and rails. Check pin 1 reaches negative and pins 8 and 4 reach positive.

Only one LED works

With power off, compare the two opposite current paths at pin 3 with the schematic. The upper LED anode faces positive; the lower LED cathode faces ground. Keep both 470 ohm resistors.

Lights remain steady

Check the link between pins 2 and 6 and the 47k feedback connection to pin 3. Pin 7 is unused in this circuit.

Flashing is unexpectedly fast

Check 47k versus 470 ohms and 10µF versus a different capacitor value. Disconnect before changing anything.

Timer or capacitor gets warm

Remove the battery immediately. Check chip orientation, shorts and the electrolytic stripe toward ground before trying again.

These checks supplement your volume guide. They do not replace its schematic or certify your wiring.

Ask ALAI about Volume 001

Members can ask with this volume's circuit facts preloaded. Sign in to check your access or meet ALAI.

Free Shipping

On orders over $50

Fast Shipping

Ships within 24 hours

Secure Checkout

256-bit SSL encrypted

Family Owned

Since 2013 in Pine Hill, NJ

Follow us for tutorials, product demos, and maker inspiration!
Added to Cart!