I have a bunch of old wall adapters from other electronics lying around and want to use one to power my Arduino instead of USB. How do I know which ones are safe to use and which will fry the board?
TechCrate editorial answer
Bench Answer
Look for four things on the label: **DC output** (not AC), **7-12V** (9V is ideal), **center-positive polarity**, and a barrel plug around 2.1mm — if all four check out, it's safe to use on the Arduino's barrel jack. **Breaking those down:**
1. **Output voltage.** Arduino boards accept **7-12V DC** through the barrel jack; the onboard regulator steps it down to 5V. Avoid anything above 12V (regulator overheating risk) or below 7V (brownout/reset risk from lack of headroom). 2. **AC vs DC.** The label says either "AC/AC" or "AC/DC" — you want **DC output**. An AC-output adapter (common on old phones/answering machines) can cause real damage on a DC barrel jack.
1. **Output voltage.** Arduino boards accept **7-12V DC** through the barrel jack; the onboard regulator steps it down to 5V. Avoid anything above 12V (regulator overheating risk) or below 7V (brownout/reset risk from lack of headroom). 2. **AC vs DC.** The label says either "AC/AC" or "AC/DC" — you want **DC output**. An AC-output adapter (common on old phones/answering machines) can cause real damage on a DC barrel jack.
Unlock the full bench walkthrough
Members get the complete diagnostic workflow, every measurement to take and the verification checklist.
Unlock Digital VIP · $4.99/mo →