-->

Potentiometer wired but Serial Monitor shows the value jumping around randomly

D
Devon M.
Asked on June 23, 2026 • TechCrate Bench Q&A
Reading a 10K potentiometer on A0 with analogRead and printing to Serial Monitor. Even when I am not touching the knob at all, the numbers jitter around by 10-20 randomly instead of staying still. Is my pot broken?
TechCrate editorial answer

Bench Answer

Your pot is very likely fine — check that all three pins are connected (both outer legs to 5V and GND, wiper to A0); a floating third pin is the #1 cause of this exact jitter. Small jitter can also just be normal ADC noise, fixable with a simple averaging function in code. **1. Check the wiring first.** A voltage-divider pot needs all three pins: one outer pin to **5V**, the other to **GND**, and the middle (wiper) pin to **A0**.
Unlock the full bench walkthrough

Members get the complete diagnostic workflow, every measurement to take and the verification checklist.

Unlock Digital VIP · $4.99/mo →
← Back to TechCrate Community HubAsk a Bench Question →

Build Hands-On Projects Every Month with TechCrate

Get complete component kits, companion video guides, and 24/7 AI bench troubleshooting delivered to your door starting at $14.99/mo.

Get TechCrate Today (Free Shipping) →

Free Shipping

On orders over $50

Fast Shipping

Ships within 24 hours

Secure Checkout

256-bit SSL encrypted

Family Owned

Since 2013 in Pine Hill, NJ

Follow us for tutorials, product demos, and maker inspiration!
Added to Cart!