My multimeter is showing 0 volts no matter where I probe, but I can see the LED is lit so I know current is flowing. Battery snap connector is new. Am I doing something wrong with the meter itself?
TechCrate editorial answer
Bench Answer
Since the LED is lit, voltage is clearly present, so this is almost certainly a **meter setup issue**, not a dead circuit — check that the dial is on a DCV range (not ACV) and that the red probe is in the VΩmA jack, not the 10A/20A jack. Other common culprits:
1. **Dial on the wrong function.** Cheap meters share dial positions between DC voltage ranges (usually marked V with a straight line or "DC") and other functions like AC volts (V with a wavy line ~).
1. **Dial on the wrong function.** Cheap meters share dial positions between DC voltage ranges (usually marked V with a straight line or "DC") and other functions like AC volts (V with a wavy line ~).
Unlock the full bench walkthrough
Members get the complete diagnostic workflow, every measurement to take and the verification checklist.
Unlock Digital VIP · $4.99/mo →